Speeding Up Your PPPoE Connection

If you use a Point-to-Point Protocol connection over Ethernet (PPPoE), you may
notice a delay in using the PPPoE connection after startup. By default, there is a 120
second delay but you can stop this behavior by manually configuring an IP address for
the network adapter card. If you do not use a PPPoE connection, you can skip this

1. Select Start/Connect to/Show All Connections.

2. Open the TCP/IP properties for your LAN network interface card.

3. Manually set the IP address on the TCP/IP properties to an appropriate IP address
and subnet mask for your network.

Share this

Related Posts

Next Post »

Post Your Comments Below: